Sublimation Ink by Sublimation Ink Net - Installing Your JetBlaster Sublimation Inks

Welcome to
Sublimationink.NET
your Sublimation Connection

Install Your Artainium Sublimation Inks
Epson 3000 Previous Step Remove Ink Previous Step Flush Printer	Make sure for the Epson 3000 model only you have followed the previous steps to uninstall old inks and flushed your printer Switch on the printer Open the ink door and insert the cartridges into their respective slots Close the door and wait until the ink has charged This can take up to 7 minutes Run a test print If the ink is not yet through run a couple of cleaning cycles.
Epson 900 Previous Step Remove Ink	Make sure you have removed any old inks from the printer as described in previous steps Open printer cover Press and hold the load eject button for 3 seconds until the print head moves to the left Insert your black JetBlaster ink into the printer Press the load eject button again and the print head will move to the left so you can insert the color cartridge Press the load eject button again and the printer will begin charging ink to the print head this will take about a minute When this is complete you are ready to install your software.